RIKON Power Tools 10-201 - Manual (Page 13)

13
1. Remove the hex nut (K) and outer flange (J) from the
blade arbor (I). Note: The arbor has a right hand
thread; to loosen the hex nut turn it counterclockwise.
2. Place a 10 saw blade (Z) onto the blade arbor (I),
make sure the teeth of the blade are pointing down in
the front of the table saw. Place the outer flange (J)
and hex nut (K) onto the blade arbor and snug hex
nut by hand. Place the open-end blade wrench (L) on
the flats of the inner blade flange (not shown) and
the box-end blade wrench (M) onto the hex nut and
securely tighten.
Note: The blade arbor has a right hand thread, to
tighten the hex nut turn it clockwise.
"
SEE FIG.24
Fig. 25
3. Place a square (N) onto the saw blade and against the
splitter assembly (O). Make sure the splitter is square
to table
4. Lay a straight edge (R) against the left side of the saw
blade (S) Align the splitter and make sure the
splitter is aligned to the blade.
. SEE FIG.25
SEE FIG.26
Fig.26
T
S R
CONVERSION THE SPLITTER TO RIVING
KNIFE
Note: Splitter can be used as riving knife.
1. Remove the guard assembly(C) and kick-back pawl
assembly (D) by loosing knob (A) and (B). SEE FIG.27
A
B
C
D
Fig.27
2. Remove the table insert, and make sure the location
pin inside the bottom of the mounting bracket is
properly insert into the location hole(E) of splitter.
SEE FIG.28
Fig.28
3. Tighten the Knob (F) and re-install the table insert.
E
F