Operating procedures – RIKON Power Tools 25-200 User Manual

Page 10

Advertising
background image

5.1. ON/OFF SWITCH (Fig.13)

· To switch ON = press green switch button.

· To switch OFF = close cover or press red switch button.

· To unlock the switch cover push the pin on the stop cover.

5.2 SURFACE PLANER MODE:

- The workpiece rests on top of the infeed table.
- The workpiece is cut on the underside.
- The feed direction of the workpiece is exactly opposite than

when thickness planing.
Workpiece dimensions
- Length: use a push stick to feed workpieces shorter than 12" ;

for workpieces over 60" use support rollers.
- Width: max. 12".
- Thickness: min. 1/4".
Note: The max. depth of cut for a single pass is 1/8".

1. Assume proper operating position:
position yourself to one side of the infeed table.
2. Set jointer fence as required.
3. Set planing thickness.
4. Place workpiece against jointer fence .
5. Adjust cutterhead cover:
- when planing narrow edges (jointing) or workpieces more than

3" thick:
Set cutterhead guard from the side against the workpiece

(Fig16).

5. Operating Procedures

A

FIG. 13

FIG. 14

FIG. 15

FIG. 16

10

Advertising