RIKON Power Tools 25-200 - Manual (Page 11)

- Planing the face of a plank or workpieces up to 3" thick: lower
cutterblock cover from top onto workpiece. Adjust cutterhead
guard so that the undermentioned distances are not
exceeded in any position:
rear edge (A, Fig.17) – workpiece max. 1/64";
front edge (B, Fig.17) – workpiece max. 5/64".
6. Start motor.
Caution: The use of push blocks is necessary when face planing
thin material.
7. Turn the machine on and place the workpiece on the infeed
table. Feed the workpiece toward the cutterhead exerting
downward pressure until the workpiece clears the cutterhead on
the outfeed table side.
max. 3 mm max. 2 mm
A B
FIG. 17
Note:
Before using the jointer fence:
1. Set a try square (C, Fig.18) against the fence extrusion (D,
Fig. 18)
2. Loosen both hex bolt (E, Fig.18) and adjust the set screws (F,
Fig.18) until fence extrusion is square with the jointer table.
3. Tighten hex nuts when the fencn extrusion is exactly 90°
4. Set a mitre square against the fence extrusion.
5. Hex bolts (G, Fig.19) and adjust hex bolts until fence extrusion
is stopped exactly 45°.
C
D
E
F
FIG. 18
G FIG. 19
11