RIKON Power Tools 25-200 - Manual (Page 9)

3.6. DUST CHUTE - INSTALLATION
The dust chute complete with suction connector must be
installed for planing.
CAUTION: The contact pins on the shaft of the dust chute (A,
Fig. 9) must engage properly in the limit switch. Incorrectly
installed dust chute the machine will not start.
Connect a suitable dust collector to the suction connector of the
jointer/planer.
4. Adjustment
4.1. PLANER TABLE HEIGHT ADJUSTMENT
Per pass a maximum of 1/8" material can be removed.
Workpieces of max. 8" thickness can be planed.
Height adjustment is made with a handwheel (B, Fig.10). One
full turn of the crank changes the height of the planer bed (C,
Fig.10) by 5/32".
· Clockwise turning = raises the planer bed
· Counter-clockwise turning = lowers the planer bed. The planing
thickness is indicated on the scale (D, Fig.10).
4.2. INFEED TABLE HEIGHT ADJUSTMENT
The infeed table (E, Fig,11) is adjusted by using adjusting lever
(G, Fig.11) for edge jointing and surface planing.
· The scale (F, Fig.11) next to the adjusting lever (G, Fig.11)
corresponds to 1/32" material removal.
- After adjustment, tighten ratchet lock lever (H, Fig.11)
- Per pass a maximum of 1/8" material can be removed.
4.3. JOINTER FENCE ADJUSTMENT
The jointer fence (I, Fig.12) provides lateral support for the
workpiece when surface planing.
· After loosening the ratchet lock lever (J, Fig.12) the jointer
fence can be adapted to the workpiece width.
· After loosening the ratchet lock lever (K, Fig.12) & lock pin
(L, Fig.12) the jointer fence extrusion can be tilted to the angle
between 0°- 45°.
B
C
D
E
H
G
F
I
K
J
I
A
FIG. 9
FIG. 10
FIG. 11
FIG. 12
L
9