Seca 466 - Manual (Page 54)

54 •
4. Keep the Feed key depressed and switch on the
device.
The Power LED flashes.
5. Release the Feed key.
6. Close the paper compartment cover.
The Paper LED comes on.
The type of paper currently set is displayed by the
Power LED and the Error LED.
7. Press the Feed key until the Power and Error
LEDs display the type of paper in use.
8. Open and close the paper compartment cover.
The set paper type is now stored.
NOTE
As no paper has yet been inserted, the Power,
Error and Paper LEDs ("Paper" error message)
come on. As soon as you have inserted paper,
only the Power LED is on. The device is then
operational.
Insert paper roll Proceed as outlined below to insert paper in the printer.
1. Ensure that the device is switched off.
CAUTION!
Burns and cuts
− Do not touch the print head. This is very hot
immediately after printing.
− Do not touch the paper cutter.
− Do not hold the paper by the edges. These
too can cause cuts.
2. Open the paper compartment cover.
3. Insert the paper roll.
NOTE
Ensure that the paper roll is correctly aligned.
See adjacent illustration.
4. Close the paper compartment cover until you hear
it engage.
The device is operational.
Type of paper Power LED Error LED
Labels On Off
Thermal paper Off On
Black Mark paper On On
POWER
FEED
ERROR
PAPER