Seca 466 - Manual (Page 72)

72 •
7.2 Remove paper jam
CAUTION!
Burns and cuts
− Do not touch the print head. This is very hot
immediately after printing.
− Do not touch the paper cutter.
− Do not hold the paper by the edges. These
too can cause cuts.
1. Switch off the printer.
2. Open the paper compartment cover.
NOTE
If the paper cutter has not returned to its initial
position, the paper compartment cover cannot
be opened. In this case, retract the paper cutter
manually (see "Reset paper cutter (seca 466)"
on page 72). Then open the paper
compartment cover.
3. Carefully remove jammed paper and paper
residues.
4. Insert the paper roll.
5. Close the paper compartment cover until you hear
it engage.
7.3 Reset paper cutter (seca 466)
If objects have got into the paper feed section or if the
paper has jammed, the paper cutter may not return to
its initial position. In this case, the Error LED flashes.
NOTE
If the paper cutter does not return to its initial
position, the paper compartment cover cannot
be opened.
Proceed as follows to retract the paper cutter to its
initial position manually.
Poor print quality Print head dirty
- Clean print head (see "Reset paper cutter (seca 466)"
on page 72)
Fault Cause/Remedy