Seca 466 - Manual (Page 71)

What should I do if …? • 71
English
Error LED flashing Macro executing
- Wait until macro complete.
Error LED flashing Power supply too low:
• power supply unit defective
- Replace power supply unit
• printer defective
- Do not continue using printer. Use replacement
device
Error LED flashing Power supply too high:
• power supply unit defective
- Replace power supply unit
• printer defective
- Use substitute device
"MSG For Children only"
message appears on
the printout • No reference data are available for the patient age
entered
- Check age entered and correct if necessary
"MSG image not loaded
to printer" message
appears on the printout • No logo saved on the SD card
- Select a logo and save it on the SD card - see "Select
your own logo (logo)" on page 61
Printing does not start. • It was not possible to transmit measurement results to
the printer.
- Ensure that the printer is switched on.
• Printer not integrated in wireless network.
- Switch off the scale or height measuring device
- De-energize the printer and its wireless module
- Set up the wireless network again.
• Nearby HF equipment (e.g. mobile phones) is
interfering with reception.
- Make sure that HF equipment is kept at least 1 metre
away from transmitters and receivers in the seca
wireless network.
Incorrect time and date
on printout • Date and time not set
- Set date and time using a seca 360° wireless scale
or height measuring device (see instruction manual
for the
- seca 360° wireless device used).
• Internal battery of wireless module exhausted.
- Contact seca Service.
Fault Cause/Remedy