AW Gear Meters EMO-1005 - Manual (Page 21)

AW-Lake Company 8809 Industrial Drive, Franksville, WI 53126  web: www.awgearmeters.com
 Tel: 262-884-9800  Fax: 262-884-9810  Email: [email protected]
REV. 1a 05/98 EMO-1005 Manual.DOC
20
CHANNEL MODE SELECTION
Each channel card installed in an EMO-1005 is a separate microprocessor controlled system. Each
channel card has the option to designated as a Monitor, PI Controller, Closed Loop Controller
(CLC) or a Complex Ratio System. To change a channel card to a different mode press the following
key sequence:
CHA -> DP -> ENT -> LIM
When this is done the following screen will appear:
MODE: 1=MON 2=PID
3=GON 4=TRA 5=RA
The next five sections will explain what happens when these numbers are selected.
For standard PID operations, select Mode #4, TRANSPARENT - This replaces Mode #2 for all
uses.
MONITOR MODE (Select 1)
When a 1 is selected in the above screen, the channel card will be designated as a Monitor card. In the
standard monitor mode the EMO-1005 will read the incoming frequency, display the derived rate and
total on the display, and adjust the Analog Outputs and Limits accordingly.
Using the 2 line display, both Rate and Total or Rate from 2 different channels could be
monitored simultaneously - or any combinations of Rate, Total and Peak Rate.