Fire-Lite IPDACT-2UD Technical Reference - Manual (Page 11)

The IPDACT-UD basically consists of three elements:
•
The Analog Subscriber Line Circuit module (Telephonic module).
•
The V32 modem module.
•
The Control module.
Figure 6. IPDACT-UD circuit details.
The device CPU, memory and the LAN (identifiable through the RJ-45
connector) are found in the control module. This manages all the information
procedure and the sending of the said information through an IP network over
the LAN.
The telephonic module physically supports the control and contains all the
connection points with the control panel. This manages the entire telephonic
interface with the control panel and the client telephone network (public
telephone network termination point and client phone wiring).
The V32 modem module adds the necessary elements to make telephonic
data calls to the control panel and so support upload/download functionality.
From a configuration / monitoring point of view, the IPDACT-UD possesses
LEDs that permit you to view the status of the various elements, from the P1
jumper to control various aspects and a telephonic console. This telephonic
console is accessible from the connection to the control panel (TO-AP) and
requires an analog telephone with tone dialing.
The IPDACT-UD has an asynchronous console which permits you to monitor /
configure the device through an asynchronous terminal.
IPDACT-UD - Description
II-8
Doc.DM385-I
Rev. 2.0