Fire-Lite IPDACT-2UD Technical Reference - Manual (Page 26)

IPDACT-UD - Configuration
III-23
Doc.DM385-I
Rev. 2.0
The register is composed of one field containing up to 16 DTMF digits. By
default there is no configured value.
VisorALARM message encryption key
The Teldat VisorALARM uses this key to encrypt the messages sent to the
IPDACT-UD. This must be entered twice in order to validate it.
The register is composed of one field containing up to 16 DTMF digits. By
default there is no configured value.
Keep-Alive Interval (sec.) (KEEP_ALIVE_INTERVAL)
Time interval when the IPDACT-UD executes a connectivity test with the
Teldat VisorALARM. For this, a keep-alive frame is sent and a response is
expected from the IP receiver.
The register is made up of one 5-digit field. The interval is expressed in
seconds and admits values between 00000 and 90 seconds. The range of
values this register can take comply with the UL1610 section 62.10. The field
contains a verification digit for the number. Default value is 00010.
Retries after failed keep-alive ( KEEP ALIVE RETRIES )
If the IPDACT-UD, on executing the connectivity test with the Teldat
VisorALARM, does not receive a response within the “time-between-send-
keep-alive-retries” seconds, the IPDACT-UD repeats the process of sending
the keep-alive frame. Should there be no response within same time interval,
the IPDACT-UD repeats the process until the number of retries configured in
the register has been completed. The connection with the Teldat
VisorALARM is considered down once the number of configured retries in
this register has been executed and subsequently the control panel can
access the telephone network.
The register is made up of one single digit field. This admits values between
1 and 9. Default value is 3.
Time between send keep-alive retries (secs) (KEEP_ALIVE_RETRIES_TIME)
Time measured between sending of keep-alive frames when a possible
connectivity problem has been detected with the IP VisorALARM receiver.
The register is made up of one single digit field. This is expressed in seconds
and admits values between 3 and 9.
The field contains a verification digit for the number. Default value is 3.
Backup Teldat VisorALARM IP address