HT instruments HT8000 - Manual (Page 9)

HT8000
EN - 8
4.3.2. DC Voltage generation
CAUTION
Maximum input for DC voltage is 30V. Do not attempt to take any voltage
measurement exceeding such limit to avoid the risk of electrical shock and
damages to the instrument.
Fig. 3: DC Voltage generation
1. Press INPUT/OUTPUT key and select the generation mode. The “OUTPUT” symbol is
displayed
2. Press V/mV key and select the desired measurement unit. The symbol “V” or “mV” is
displayed
3. By means arrow keys
 and  (see Fig. 1 – parts 9, 10, 11 and 12) to set the value of
output generated voltage. The maximum set values are 100mV and 10V. The voltage
value will be displayed
4. Insert the red plug into V jack and the black plug into COM jack
5. Connect the red and black test leads to the positive and negative poles of the external
device respectively (see Fig. 3).
6. For the generation of a negative value of voltage connect the test leads in the opposite
direction than shown in Fig. 3