In-Situ Virtual HERMIT Tutorial - Manual (Page 14)

14 Getting Started
3. After all of the TROLLs have been found, the wizard will activate the OK button
(the check mark). Click OK.
4. You will be prompted to select one of the TROLLs as the “Pump Well TROLL”.
This TROLL will be used as the reference for step times and drawdown
calculations. Click OK.
5. You will be prompted to connect to the TROLLs that were found. If you click Yes,
the TROLLs will be connected and become active. If you click No, you can
connect later, either with the Virtual HERMIT software or Win-Situ Mobile
software on the RuggedReader handheld PC.