KEPCO ATE-DMG SERIES - Manual (Page 29)

ATE-DMG 042314 2-5
2.3 SOURCE POWER REQUIREMENTS
This power supply is normally configured for operation on a single phase, nominal 115V a-c line.
For conversion to other a-c source voltages, refer to Figure 2-4. Select your nominal source volt-
age and change the links on the barrier strip of T201 according to the table provided in Figure 2-
4. The circuit breaker (CB101) remains equally effective at all input voltages.
FIGURE 2-4. A-C INPUT SOURCE VOLTAGE SELECTION, ATE-DMG FULL RACK SERIES
TABLE 2-4. INPUT/OUTPUT PIN ASSIGNMENTS FOR REMOTE CONTROL
CONNECTOR PIN SIGNAL NAME FUNCTION
IEEE 488
PORT
1 D I 01 I/O Line
2 D I 02 I/O Line
3 D I 03 I/O Line
4 D I 04 I/O Line
5 EOI End or Identify
6 DAV Data Valid
7 NRFD Not Ready for Data
8 NDAC Not Data Accepted
9 IFC Interface Clear
10 SRQ Service Request
11 ATN Attention
12 SHIELD Shield
13 D I 05 I/O Line
14 D I 06 I/O Line
15 D I 07 I/O Line
16 D I 08 I/O Line
17 REN Remote Enable
18 GND Ground (signal common)
19 GND Ground (signal common)
20 GND Ground (signal common)
21 GND Ground (signal common)
22 GND Ground (signal common)
23 GND Ground (signal common)
24 LOGIC GND Logic Ground