Asus Pedestal Server TS100-E4/PI2 - Manual (Page 83)

ASUS TS100-E4/PI2 4-21
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.58 (C)Copyright 1985-2004, American Megatrends, Inc.
BIOS SETUP UTILITY
Advanced
Select Remote Access
type.
Configure Remote Access type and parameters
Remote Access [Enabled]
Serial port number [COM1]
Base Address, IRQ [3F8h,4]
Serial Port Mode [115200 8, n,1]
Flow Control [None]
Redirection After BIOS POST [Always]
Terminal Type [ANSI]
VT-UTF8 Combo Key Support [Enabled]
Media Type [Serial]
4.4.3 Remote Access Configuration
Remote Access [Disabled]
Enables or disables the remote access feature.
Configuration options: [Disabled] [Enabled]
The following items appear only when the Remote Access item is set to
[Enabled].
The items in this menu allows you to configure the Remote Access fea-
tures. Select an item then press <Enter> to display the configuration
options.
Serial port number [COM1]
Allows you to select a serial port for console redirection. Configuration op-
tions: [COM1] [COM2]
Serial Port Mode [115200 8, n,1]
Allows you to select a serial port mode. Configuration options: [115200
8,n,1] [57600 8,n,1] [38400 8,n,1] [19200 8,n,1] [09600 8,n,1]
Flow Control [None]
Allows you to set the flow control for console redirection. Configuration
options: [None] [Hardware] [Software]
Redirection After BIOS POST [Always]
Sets the redirection mode after the BIOS Power-On Self-Test (POST). Some
operating systems may not work when this item is set to Always.
Configuration options: [Disabled] [Boot Loader] [Always]