KYORITSU 2413F User Manual
Page 19
― 17 ―
５−５ How to Use Data Hold Function
Push in the Data Hold button to freeze the reading. This is especially
useful for taking a reading in a dimly lit or hard-to-reach locations. The
display can be observed away from the conductor. Push the button
again to release the reading.
５−６ Analogue Output: How to Use Model 7073 Output Cord
AC and DC output can be obtained by inserting optional Model 7073
output cord into the two-way analogue output terminal (3).
AC Output
Can be monitored by connecting a digital multimeter to analogue output
terminal or observed as a waveform by connecting an oscilloscope.
For true RMS measurements, connect a true-RMS-reading digital
multimeter.
DC Output:
Can be monitored by connecting a digital multimeter, or a recorder,
which enables many hours of monitoring. See Figure 8. With the 2413F
in the peak hold mode, DC voltage corresponding to 1/
√2 of a peak
current value can be held and output.
Refer to section 5-3, How to Use Peak Hold Function.