KYORITSU 2413F - Manual (Page 4)

Following symbols are used on the instrument and in the instruction
manual. Attention should be paid to each symbol to ensure your safety.
Refer to the instructions in the manual.
This symbol is marked where the user must refer to the instruction
manual so as not to cause personal injury or instrument damage.
Indicates an instrument with double or reinforced insulation.
Indicates that this instrument can clamp on bare conductors when
measuring a voltage corresponding to the applicable Measurement
category, which is marked next to this symbol.
DANGER
●Never make measurement on a circuit above 600VAC.
●Do not attempt to make measurement in the presence of
flammable gasses, fumes, vapor or dust. Otherwise, the use of
the instrument may cause sparking, which can lead to an
explosion.
●Transformer jaw tips are designed not to short the circuit under
test. If equipment under test has exposed conductive parts,
however, extra precaution should be taken to minimize the
possibility of shorting.
●Never open the battery compartment cover when making
measurement.
●Never attempt to use the instrument if its surface or your hand is
wet.
●Do not exceed the maximum allowable input of any
measurement range.
●Never try to make measurement if any abnormal conditions, such
as broken Transformer jaws or case is noted.
●The instrument is be used only in its intended applications or
conditions. Otherwise,Safety functions equipped with the
instrument doesn't work, and instrument damage or serious
personal injury may be caused.
WARNING
●Never attempt to make any measurement if any abnormal
conditions are noted, such as broken case, cracked test leads
and exposed metal parts.
●Do not install substitute parts or make any modification to the
instrument Return the instrument to Kyoritsu or your distributor
for repair or re-calibration.
●Do not try to replace the battery if the surface of the instrument is wet.
― 2 ―