Revo REHVDPTZ22-1 INSTRUCTION MANUAL - Manual (Page 32)

• ORIGIN OFFSET
OFFSET SETUP
(CTRL KEY)
PAN OFFSET : 000.0
TILT OFFSET : 000.0
ENABLE : OFF
SAVE AND EXIT(ESC TO CANCEL)
This feature is useful to align a new dome camera exactly the same as the previously installed
dome camera.
Dome camera’s origin set and all data initialize option do not override offset values. Only the
default set option in this menu will set the offset value to zero. This can be used to avoid
ceiling obstructions.
• DOME RESET
DOME RESET
ARE YOU SURE ?
CANCEL
OK
This feature is used to re-calibrate the orientation of a selected dome camera. Origin offset
value is not affected by this function. (Offset is still valid after origin set.)
• SYSTEM MENU
SYSTEM MENU
MOTOR SETUP
PASSWORD EDIT
ORIGIN CHECK
CALIBRATION : ON
PASSWORD ENABLE : OFF
MENU TIME OUT : OFF
BLINK CURSOR : ON
DOME ANSWER : OFF
SAVE AND EXIT(ESC TO CANCEL)
CALIBRATION : ON(Auto origin check) / OFF
PASSWORD ENABLE : ON(requires the password to enter menu) / OFF
MENU TIME OUT : ON(5mintues) / OFF(always menu display)
BLINK CURSOR : ON / OFF(no blinking cursor)
DOME ANSWER : ON / OFF(no acknowledge command from the dome)
This option is helpful to escape the collision of the command using some DVR.
26