SHIMPO DT-209X-S12 - Manual (Page 12)

8
Average
mode
• The max, min, average, last and time of measurement
can be stored in memory via power button.
• The unit can store a maximum of 30 blocks
• Each block of data is based from the time the power
button was first pressed and then released. Within that
time average values are calculated and stored in memory
together with the time of measurement.
• Only the final set of values are displayed from the
tachometer in this mode. To review other blocks of
memory, the DT-209X has to download data using the
software and a computer.
Flowchart Diagram
Standard Mode
Standard Mode Memory Block 1 “n01”
Memory Block 2 “n02”
Memory Block 24 “n24”
Memory 1 “M1”
Memory 10 “M10”
Memory 2 “M2”
Memory 3 “M3”
Memory 4 “M4”
Pressing the Memory button Pressing the Power button
• There are 24 blocks in
Standard mode.
• Each block contains 10
memory points
• Total of 240 memories can
be stored.