SHIMPO DT-209X-S12 User Manual
Page 68
Measured value is divided by 2
There are two versions of the DT-209X,
Standard Version DT-209X is set for 6 inch
circumference wheel, and DT-209X-S12 is set
to 12-inch circumference wheel. Check the
front label for proper wheel attachments.
While storing values it shows "CCCCC"
The memory button was pressed for 5
seconds.
Could not measure Yards, feet, inches and meters per
minute
These linear rate measurements are availab
in cont
le
act mode using the wheel attachment.
Could not measure length
These measurements are available in contact
mode, using the wheel attachment.
Check battery orientation and reinstall.
Check the trig
the table immediately.
Different USB port. For every USB port that
will be used, the USB driver is required to be
installed.
Useful Links:
For inquiries email us at
. Our website address is
Tel No. 1-800-237-7079.
oducts and current product
For applications check our appli
section under the Resource
Brand new batteries no display.
While using the software, could not see values stored on
ger setting values.
Found new hardware icon appears every time the DT-
209X is plugged in to the computer. (Even after previous
installation of USB driver was successful.)
www.shimpoinst.com
.
Check our website for additional Shimpo Pr
updates.
cation notes
Center.
64