SHIMPO DT-209X-S12 - Manual (Page 40)

Main Screen Description
1. Exit – terminates the program and exits the software
2. USB Mode – Online measurement (Note: Make sure that the DT-209X
Handheld mode selector switch is set to USB. Failure to do this will not
allow communication between host computer and the DT-209X).
3. Standard Memory Mode – Mode option for downloading stored data from
the tachometer in Standard Mode. Each memory block is separated by
tabs located on the top of the table (Refer to Standard Mode Operation in
this section).
4. Average Memory Mode – Mode option for downloading stored data from
the tachometer in average memory.
Keystrokes Shortcut
Tab Name Key combination
Exit Alt + E
USB Memory Mode Alt + U
Standard Memory Mode Alt + S
Average Memory Mode Alt + A
36