SUOMY 3LOGY Helmet - Manual (Page 21)

19
2.2 Assembly
Position the cheek section by matching the holes on it to the holes on the shell, then tighten the three screws [(3) see Fig. 2].
Then re-assemble the protective shield after matching it up with the housing for the three screws [(1) see Fig. 2].
3. CHIN GUARD see figure 3
The protective chin guard provided with the SUOMY 3LOGY helmet transforms the SUOMY 3LOGY jet helmet into a full face helmet.
The double P/J approval means in this configuration the SUOMY 3LOGY has been approved in accordance with safety requirements.
The chin guard is equipped with an ON/OFF air vent controlled by an external button. (Button lowered for the open position and raised for the
closed position).
This air vent allows effective air entry to the inside of the visor, to prevent condensation forming and provide sufficient ventilation inside the helmet.
3.1 Removal
To remove the chin guard first remove the protective shields as outlined in point 2.1.
Remove the three screws under the shield and then the chin guard itself.
3.2 Assembly
Position the chin guard by matching the holes on it to the holes on the shell and tighten the three fixing screws.
Then reassemble the protective shields as outlined in point 2.2.
INTERNAL SUPPORTS
The SUOMY 3LOGY's internal support, comprising the upper head guard and two cheek pads, is completely removable and washable.
Made with high quality anti-allergy fabric which has undergone anti-bacterial treatment.
4. REMOVABLE INTERNAL HEAD GUARD see figure 4
4.1 Removal
The internal head guard is fastened to the shell via 4 attachment points comprising:
• a flap positioned in the upper part of the helmet inserted between the protective polystyrene and the external shell (F)
• two side pieces of Velcro (A-B)
• a front attachment and release system on the frame directly fixed to the polystyrene via a co-moulded system patented by SUOMY (C-D-E)
To remove the head guard first remove the upper part by pulling it towards the inside of the helmet until it is freed completely.
Detach the two side Velcro strips (A-B) by carefully pulling until they are completely detached from the fixed part of the polystyrene.
USE and MAINTENANCE ENG