West Control Solutions KS 42-1 - Manual (Page 25)

Configuration level
Operating KS4x-1 25 Configuration
Name Value range Description Default
HC.SC
Solid state relay (SSR) short circuit signal 0
0 not active
1 active
timE
Timer end signal 0
0 not active
1 active
P.End
Programmer end signal 0
0 not active
1 active
FAi.1
FAi.2
INP1/ INP2 error signal 0
0 not active
1 active
fOut Forcing OUT1 (only visible with BlueControl!) 0
0 No forcing
1 Forcing via serial interface
Out.2
Configuration parameters Out.2 as Out.1 except for: Default Y.1 = 0 Y.2 = 1
Out.3
Name Value range Description Default
O.tYP
Signal type selection OUT3 0
0 relay / logic (only visible with current/logic voltage)
1 0 ... 20 mA continuous (only visible with current/logic/volt.)
2 4 ... 20 mA continuous (only visible with current/logic/volt.)
3 0...10 V continuous (only visible with current/logic/voltage)
4 2...10 V continuous (only visible with current/logic/voltage)
5 transmitter supply (only visible without OPTION)
O.Act
Method of operation of output OUT3 (only visible when
O.TYP=0)
1
0 direct / normally open
1 inverse / normally closed
Y.1
Y.2
Controller output Y1/Y2 (only visible when O.TYP=0) 0
0 not active
1 active
Lim.1
Lim.2
Lim.3
Limit 1/2/3 signal (only visible when O.TYP=0) 1
0 not active
1 active
LP.AL
Interruption alarm signal (LOOP) (only visible when
O.TYP=0)
0
0 not active
1 active
HC.AL
Heat current alarm signal (only visible when O.TYP=0) 0
0 not active
1 active