Banding mounting, Ool (see – Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities User Manual
Page 15
Installation Manual
7 . Place a lock washer and nut on each bolt and tighten the nuts 100…150 inch-pounds to ensure the gateway is
sufficiently secured to the pole .
8 . Repeat Steps 7 and 8 for attaching the V-block clamp mounting hardware to the bottom bolts of the
mounting backplate .
Side View
Back View
Side View
Figure 12: Completed gateway mounting
Banding Mounting
Banding mounting equipment is sized to mount the gateway on a 2-1/2…24-inch outer diameter pole .
MPORTTNT
I
When using the banding mounting kit for the gateway, use BAND-IT Idex installation practices. Refer to
for more information. This is especially applicable when
mounting on a non-tapered vertical pole, as the banding could loosen over time resulting in the unit sliding down the pole.
To mount the gateway on a pole, gather the banding and locking equipment .
Figure 13: Banding and locking equipment
Page 15
March 2014