Overview, Product description, License requirements – Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities User Manual

Page 5: Product unpacking and inspection

Advertising
background image

Installation Manual

OVERVIEW

This manual contains installation instructions for the ORION® Fixed Network (SE) II network gateway transceiver .

Proper performance and reliability of the gateway depends upon installation in accordance with these instructions .

NOTE:

N

Refer to the Gateway Configuration Software manual available at

www.badgermeter.com

for instructions on

configuring and programming the gateway .

Product Description

The ORION Fixed Network II network gateway transceiver (”gateway“) is an easy-to-install, easy-to-deploy unit that collects

metering data from the ORION Fixed Network meter endpoints in the area .

The gateway is available with a dual CDMA/LAN or

GPRS/LAN network backhaul and LAN only (with power or PoE) .

The network backhaul is used to se

nd the requested metering data back to the utility where the data can be used to better

manage utility operations and provide improved customer service . Reading data management software manages this data

transfer process and includes myriad tools and standard reports, as well as the ability to create any user-defined reports .

NOTE:

N

Actual product markings may vary slightly from the images shown in this manual .

License Requirements

This device complies with Part 15 of FCC rules . Operation of this device is subject to the following conditions: (1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that

may cause undesired operation of the device .

In accordance with FCC regulations, “Code of Federal Regulations” Title 47, Part 2, Subpart J, Section 1091, transmitters pass

the requirements pertaining to RF radiation exposure . However, to avoid public exposure in excess of limits for general

population (uncontrolled exposure), a 20-centimeter distance between the transmitter and the body of the user must be

maintained during testing .

No FCC license is required by a utility to operate an ORION Fixed Network meter reading system .

This device complies with Industry Canada license-exempt RSS standard(s) . Operation is subject to the following two

conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device .

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence .

L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur

de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre

le fonctionnement .

MPORTTNT

I

The Federal Aviation Administration prohibits operating transmitters and receivers on all commercial aircraft. The ORION

Fixed Network II network gateway transceiver is considered an operating transmitter and cannot be shipped by air.

Changes or modifications to the equipment that are not expressly approved by Badger Meter could void the user’s

authority to operate the equipment. Only properly trained and authorized personnel should install and/or maintain

this equipment.

Product Unpacking and Inspection

Upon opening the shipping container, visually inspect the product and applicable accessories for any physical damage such

as scratches, loose or broken parts, or any other sign of damage that may have occurred during shipment .

NOTE:

N

If damage is found, request an inspection by the carrier’s agent within 48 hours of delivery and file a claim with the

carrier . A claim for equipment damage in transit is the sole responsibility of the purchaser .

Page 5

March 2014

Advertising
This manual is related to the following products: