Milestone Paxton Integration Component - Manual (Page 10)

XProtect Paxton Integration Plug-in User's Guide
www.milestonesys.com Page 10 Configuration
To establish the connection from the XProtect server to the Net2 server, start the XProtect Management
Client/Application and use
Site Navigation to locate the “Net2 Servers” node as illustrated here:
Figure 4: The plug-in is found by expanding the MIP Plug-ins tree.
Right click on the Net2 Servers panel, choose Add New and fill out the relevant information.
Figure 5: Define a server
The Name field defaults to Paxton but can be changed if needed. Change the Server name or IP address if the
Net2 server is running on another computer. Finally enter the correct password for the OEM Client. Click the OK
button to create the connection.
Once this configuration step is completed, the configuration of the Net2 system is fetched by clicking the Refresh
button. After a short delay, it will bring up an overview of the doors defined in the Net2 server. The Refresh button
has to be clicked again to refresh the list if the configuration of the Net2 server is changed at a later point in time.
Define mappings between doors and cameras
The associations between doors (or access control units per se) and cameras must be configured for the
Milestone Paxton Integration component to be able to automatically associate events from Net2 doors with
cameras in the XProtect configuration. This is not a mandatory step, but it will ease the succeeding configuration
and its maintenance considerably.