Setting a data length, Setting a stop bit length, Setting a parity – TOHO ELECTRONICS TTM200 User Manual
Page 16: Setting a bcc check, Setting a communications speed, Setting an address, Setting a response delay, 6 setting a communications speed, 7 setting an address, 8 setting a response delay
16
5.2 Setting a data length
5.3 Setting a stop bit length
5.4 Setting a parity
5.5 Setting a BCC check
The BCC check is disabled.
Stop bit 1
Stop bit 2
No parity
Odd parity
Even parity
Data length, 7 bits
Data length, 8 bits
Communication parameter
5.6 Setting a communications speed
While in the "Set a communications speed" screen on the preceding page, operate the ▲ and ▼
keys to make the settings. The initial value is 9.6.
2400 BPS
4800 BPS
9600 BPS
19200 BPS
38400 BPS
Communication parameter
5.7 Setting an address
While in the "Set a communications address" screen on the preceding page, operate the ▲ and ▼
keys to make the settings. The initial value is 1.
Setting range: 1 to 99 stations
(It cannot be set to a 0.)
5.8 Setting a response delay
Set a time from the time when the high-level computer finished sending a "request message" until
the time when it delivers the line and enters an input state.
While in the "Set a response delay" on the preceding page, operate the ▲ and ▼ keys to make the
settings. The initial value is 0.
Setting range: 0 to 250msec
* If the response delay is set to a short setting, the communications may not be conducted normally.
* In a real operation, the processing time for this product will be added, in addition to the response
delay.