Table of identifiers (codes) – TOHO ELECTRONICS TTM200 User Manual
Page 38
38
10. Table of identifiers (codes)
For the setting range, options, initial values, and similar parameters, see the operation manual for
this system.
Note: 1. The R/W to characters that do not meet the display conditions responds with "NAK2."
2. □in the identifier table indicates a space (ASCII code:20H).
3. L/B is not applicable during MODBUS communications. (L/B is usable only with
TOHO communications.)
Run mode
toho
modbus
Screen
character
Name
Command Remark
Identifier
Absolute
(DEC)
Relative (hex)
PV1
40001
0000
Measuring temperature
RLB
HHHHH: Overscale
LLLLL: Underscale
At L/B
00000: Displays PV alone
00001: Displays SV alone
00002: Displays PV/SV
STS
40003
0002
Step SV screen
RWLB
STM
40005
0004
Step time monitor
RWLB
PRM
40007
0006
Operating screen
Run operation
W
LB
00000: Run stop
00001: Run start
00002: Run pause
00003: Run restart
00004: Step feed
Run status monitor
R
00000: Before a run
00001: In WAIT (in ramp)
00002: In a run
00003: Pause
00004: Run end
* Regarding the operating screen (PRM): Meanings of the same numerical data is different for between
reading and writing.