Alpine IVA-W505 - Manual (Page 30)

28
-EN
Rear Entertainment Function
The rear entertainment function independently routes different sources
to the front and the rear inside a car. For example, while listening to the
radio or other audio source in the front, DVD can be enjoyed in the rear
with the optional rear monitor and headphones.
1
Touch [SOURCE] on the main source screen.
The SOURCE selection screen is displayed.
2
Touch [RSE].
Rear Select display appears.
• Touching [MAIN] on the REAR selection screen will change to the
main source screen.
3
Touch the desired source such as visual (auxiliary
input, built-in DVD) to select.
• Touch [OFF] to cancel the rear entertainment function.
• When the “Setting the AUX Mode” (page 38) is set to OFF, the
auxiliary source is not displayed.
Switching Display Modes
After carrying out the steps 1 to 3 of “To display the DVD mode screen”
explained on page 29, perform the operation described below.
While your vehicle is parked, touch [WIDE] on the visual
source screen.
Each touch changes the display modes as follows:
In Mode 1 (Wide), the monitor displays a normal picture wider to
fit in a wide-screen monitor by evenly stretching out the picture
horizontally.
In Mode 2 (Cinema), the monitor displays a normal picture by
stretching out the picture horizontally and vertically. This mode is
good for displaying a cinema type picture at the 16:9 ratio.
In Mode 3 (Normal), the monitor displays a normal picture at the
center of the screen with a vertical black band at each side.
Switching the Visual Source Only
(Simultaneous Function)
You can watch the video portion of another source while listening to the
current source.
• After carrying out the steps 1 to 3 of “To display the DVD mode
screen” explained on page 29, perform the operation described
below.
1
Touch [VISUAL] on the audio source screen.
The VISUAL selection screen appears.
2
Touch a desired visual source.
The visual source is switched to the selected one.
1
Touch the visual screen to display the main control.
2
Touch [ESC].
3
Touch [VISUAL] within 5 seconds.
The VISUAL selection screen appears.
4
Touch [NORMAL].
The simultaneous function is canceled.
• To make the setting, set to “Setting the VISUAL Soft Button”
(page 39).
• If a DVD player is connected, you can receive the DVD picture/
sound.
DVD changer (DHA-S680) is connected:
Press and hold V.OUT on the remote control supplied with the DVD
player or DVD changer for more than 2 seconds. The picture and
sound of the DVD will be output.
The DVA-5210 is connected:
Press V.OUT on the remote control (included with the DVA-5210) to
output DVD picture/sound.
• The simultaneous function cannot be used when the Audio source is
in the navigation mode.
When NAV. is set in “Setting the VISUAL Soft Button” (page 39),
only the navigation screen can be recalled.
Blackout Mode On and Off
When Blackout mode is turned on, the monitor display will turn off to
reduce power consumption.
This additional power enhances the sound quality.
1
Touch [VISUAL] on the main source screen.
The VISUAL selection screen is displayed.
2
Touch [OFF].
The backlit-display portion goes out.
3
Touch [OFF] again to cancel the display backlight.
• To make the setting, set to VISUAL in “Setting the VISUAL Soft
Button” (page 39).
• If any button on the unit is pressed during Blackout mode, the
function will be displayed for 5 seconds to show the operation before
returning to Blackout mode.
MODE 1 MODE 2 MODE 3 MODE 1
(WIDE) (CINEMA) (NORMAL) (WIDE)
Canceling the Simultaneous Function