Alpine IVA-W505 - Manual (Page 60)

58
-EN
3
Remove the slot panel, then insert the Portable
Navigation device in the unit (See the illustration
below).
• The slot panel can be detached by placing a finger in the hole in the
center of the panel and pulling it down.
• If the face plate is attached, first remove the face plate, then the slot
panel. After removing the slot panel, reattach the face plate.
4
After inserting, touch [CLOSE] on the EJECT/TILT
screen.
The movable monitor will close.
5
Press SOURCE.
The SOURCE selection screen is displayed.
6
When the source name of [NAV.], on the SOURCE
selection screen is displayed, touch the desired
source name.
• For details on operation, refer to the Owner’s Manual of the Portable
Navigation device.
Removing the Portable Navigation Device
1 Press OPEN on the unit.
The display changes to the EJECT/TILT screen.
2 Touch [EJECT] of BLACKBIRD on the EJECT/TILT
screen.
The movable monitor will open.
3 Press behind the monitor.
The Portable Navigation device is removed.
1
Select the NAV. in “Setting the AUX Mode” (page 38).
2
Mount the Portable Navigation device to the optional
docking station.
The connection to the Portable Navigation device is
recognized in steps 1 and 2.
3
Press SOURCE.
The SOURCE selection screen is displayed.
4
Touch [NAV.].
For details on operation, refer to the Owner’s Manual of the
Portable Navigation device.
Operating Auxiliary Devices (Optional)
To operate your devices connected to the AUX terminals on the rear
panel of IVA-W505 (AUX mode) or to the iPod Direct connector by
using iPod Direct/RCA Interface cable (sold separately) (AUX+ mode),
follow the procedure described below.
1
Touch [SOURCE] on the main source screen.
The source screen appears on the display.
2
Touch [AUX]*
1
or [AUX+]*
2
.
The external input screen is displayed.
3
Touch [COMP. /S-VIDEO]*
3
to switch the video
signal input mode.
The mode switches with each touch.
If an Optional Docking Station is used:
Optional Portable
Navigation
Portable Navigation Slot
Push
Auxiliary Device
(Optional)
WARNING
It is dangerous (and illegal in many states) for the
driver to watch the TV/Video while driving the vehicle.
The driver may be distracted from looking ahead and
an accident could occur.
Install the IVA-W505 correctly so that the driver
cannot watch TV/Video unless the vehicle is stopped
and the emergency brake is applied.
If the IVA-W505 is not installed correctly, the driver
will be able to watch the TV/Video while driving the
vehicle and may be distracted from looking ahead and
cause an accident. The driver or other people could
be severely injured.
To activate your auxiliary devices:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the AUX mode operation has been
released. Engaging the parking brake can reactivate the AUX
mode, as long as the car’s ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of
“To activate your auxiliary devices.”
Each time the ignition is turned OFF, perform the procedure of “To
activate your auxiliary devices.”
• If you try to activate the auxiliary device while driving, the display
will show the warning-PICTURE OFF FOR YOUR SAFETY.