Brother MFC-J4610DW - Manual (Page 42)

Chapter 2
28
Paper Size and Type
(MFC-J4610DW)
2
To get the best print quality, set the machine
for the type of paper you are using.
You can use the following sizes of paper for
copies: Letter, Legal, Ledger, A4, A5, A3,
Executive and 4"
 6" (10  15 cm) and two
sizes for printing faxes: Letter or A4. When
you load a different size of paper in the
machine, you must change the paper size
setting at the same time so your machine can
fit an incoming fax on the page.
a
Press (Settings).
b
Press s or t on the Touchpanel to
display General Setup.
c
Press General Setup.
d
Press s or t to display
Tray Setting.
e
Press Tray Setting.
f
Press Tray #1 or Tray #2.
g
Do one of the following:
 If you press Tray #1, set the paper
size and type you want to set.
Press Paper Size.
Press s or t to display the paper
size options, Letter, A4, A5, EXE or
4"x6" and press the size you want
to set.
Press Paper Type.
Press s or t to display the paper
type options, Plain Paper,
Inkjet Paper, Brother BP71,
Other Glossy or Transparency
and press the type you want to set.
 If you press Tray #2, set the paper
size you want to set.
Press Paper Size.
Press s or t to display the paper
size options, Letter or A4 and
press the size you want to set.
h
Press .
NOTE
• You can use only plain paper in Tray #2.
• The machine ejects paper with printed
surfaces face up onto the paper tray in
front of the machine. When you use
transparencies or glossy paper, remove
each sheet at once to prevent smudging
or paper jams.
• When you copy using Ledger, Legal or A3
size paper, set the paper size option in
Copy mode.
Tray use in Copy mode
(MFC-J4610DW)
2
You can change the default tray the machine
will use for copies.
Auto Tray Select will allow your machine
to feed paper from either Tray #1 or Tray #2,
using the paper type and size settings from
the Copy Settings table.
To change the default setting follow the
instructions below:
a
Press (Settings).
b
Press s or t on the Touchpanel to
display General Setup.
c
Press General Setup.
d
Press s or t to display
Tray Setting.
e
Press Tray Setting.
f
Press s or t to display
Tray Use: Copy.