Brother HL 1270N - Manual (Page 114)

A-12
Appendix C
Reloading the Print Server Firmware
General
The firmware on the print server is stored in flash memory. This means that you can upgrade
the firmware by downloading the appropriate update file. To get the latest firmware update,
access the Brother WWW server on www.brother.com.
✒ Note
We recommend that you factory reset the print server if you upgrade to a later version of
software. Instructions on how to perform a factory reset can be found in the quick setup guide
that accompanies the print server.
Reloading from BRAdmin32 on the Windows
95/98/NT4.0
The BRAdmin32 utility can be used to easily re-program your Brother print server.
Start the BRAdmin32 software.
Highlight the appropriate print server. Then press select the Control menu and choose Load
Firmware. You can select more than one print server by pressing CTRL+<select> or
SHIFT+<select> on each additional print server.
There are three possible ways of sending the new software version to the print server. For
which ever method you select, you must enter a password for the print server. The default
password for the print server is “access”.