Brother HL 1270N User Manual
Page 116
A-14
3. Netware GET from a server
You must have a Netware server on your network (running IPX/SPX) and you must store
the new firmware file in the SYS/Login directory of the server. In this case, your PC
makes the print server read the firmware data from the assigned Netware server, the print
server attaches to the Netware server and reads the firmware itself..
The Data LED on the printer front panel will blink during the load process and will either go
out when the load has completed (on a 10Mbit network) or will stay lit when the printer is
connected to a 100Mbit network.
If the Data LED does not stop blinking after about two minutes, or blink periodically, check to
make sure that you correctly entered all parameters and that your network connections are
good. Then power the print server/printer off and then on again, to retry the download.