Brother HL 1270N - Manual (Page 58)

5-5
SET POP3 NAME mailboxname
SET POP3 PASSWORD emailpassword
where mailboxname is the name of the remote print server mailbox and emailpassword
is the password associated with this mailbox. Usually the mailbox name is the same as
the first part of the E-mail address that you defined previously (for example, usually if
the E-mail address is [email protected], then the mailbox name is emailprinter).
3. The print server is set by default to poll the POP3 server every 30 seconds. If you wish
to change this value, enter the command:
SET POP3 POLLING rate
where rate is the polling rate in seconds.
Type EXIT to exit the console and save the changes. You have now completed
configuring the print server.
Installing the BIP Software on a Windows
95/98/NT4.0
To install the BIP software on a Windows 95/98/NT4.0 PC, execute the following steps:
✒ Note
•
Be sure that PC is running an E-mail program (for example, Microsoft Exchange) that is
capable of sending E-mail message using either MAPI or Winsock.
•
Be sure that your E-mail server is capable of sending messages across the Internet.
Setup from the floppy disk
1. Make a backup copy of Brother Network Print Software disk and use this backup disk
for the installation process. Store the original diskette in a safe place.
2. Insert the backup installation diskette into the PC. From the Windows 95/98 Start
button, select Run. Then enter A:SETUP and press Enter to start the Brother Network
Direct Print installation program.