Canon EOS C500 PL - Manual (Page 109)

109
Special Recording Modes
3 Press the START/STOP button to begin recording.
• The tally lamp illuminates.
• [S&F] changes to [Ü S&F] while recording.
4 Press the START/STOP button again to stop recording.
• A clip is recorded at the set frame rate.
• [S&F STBY`] (during 4K and 2K modes) or [S&F STBY] (during MXF mode) appears at the top of the
screen.
• The tally lamp goes out.
Setting the Shooting Frame Rate from the Shooting Screen
If you set an assignable button to [S&F Frame Rate], you can conveniently set the shooting frame rate from the
shooting screen without having to go through the menus.
1 Set an assignable button to [S&F Frame Rate] (A 111).
2 Press the assignable button.
• The shooting frame rate will be highlighted in orange.
3 Push the joystick up/down or turn the SELECT dial to select the desired frame rate.
4 Press SET.
• The display of the shooting frame rate will return to normal.
NOTES
• You can use only one special recording mode at a time. In addition, slow & fast motion mode cannot be used
with double slot recording.
• While recording, you cannot change the shooting frame rate.
• For lower shooting frame rates, it may take approximately 1 second to stop recording.
• During special recording mode, the time code signal will not be output from the MON. terminals, TIME CODE
terminal or HD/SD SDI terminal. During 4K and 2K modes, the time code signal will be output from the 3G-SDI
terminals.
• Slow & fast motion mode will be deactivated if the special recording mode is changed or turned off. It will be
deactivated also if you change the video configuration.
• When the bit rate in the [ 4K/2K/MXF Setup] > [MXF] > [Bit Rate/Resolution] setting is set to [50 Mbps
1920x1080] or [50 Mbps 1280x720], relay recording is not available during slow motion recording.
• During 4K and 2K modes, the running mode of the time code (A 84) is set to [Free Run] and cannot be
changed. During MXF mode, the running mode is set to [Regen.]. The time code advances while video is
recorded. If the running mode of the time code is set to [Free Run] or the time code is input from an external
source, the running mode will switch to [Rec Run] during special recording mode. When special recording
mode is deactivated, the running mode will return to its previous setting.
Shooting frame rate
Playback frame rate
COP
Y