Canon EOS C500 PL - Manual (Page 118)

Custom Picture Settings
118
[Master Pedestal]
The master pedestal increases or decreases the black level. Higher settings will make dark areas brighter but
decrease contrast. This setting can be adjusted from -50 to 50. (Default: ±0)
[Master Black]
Corrects color cast in blacks.
[Red]: -50 to 50 (Default: ±0)
[Green]: -50 to 50 (Default: ±0)
[Blue]: -50 to 50 (Default: ±0)
[Black Gamma]
Controls the lower part of the gamma curve (dark areas of the image). This setting is not available when [Gamma]
is set to [Canon Log].
[Level]: Raises or lowers the lower part of the gamma curve. This setting can be adjusted from -50 to 50.
(Default: ±0)
[Range]: Selects the range in which dark areas are affected. This setting can be adjusted from -5 to 50.
(Default: ±0)
[Point]: Determines the shape of the lower part of the gamma curve. This setting can be adjusted from -1 to 50.
(Default: ±0)
[Low Key Satur.]
Adjusts color saturation in dark areas.
[Enable]: Activates/deactivates the setting. (Default: [Off])
[Level]: Specifies how saturated colors are in dark areas. This setting can be adjusted from -50 to 50.
(Default: ±0)
[Knee]
Controls the upper part of the gamma curve (highlights of the image). By compressing the highlights, you can
prevent parts of the image from being overexposed. This is not available when [Gamma] is set to [Cine 1],
[Cine 2], [Canon Log] or [EOS Std.].
[Enable]: Activates/deactivates the setting. (Default: [On])
[Slope]: Determines the slope of the gamma curve above the knee point. This setting can be adjusted from
-35 to 50. (Default: ±0)
[Point]: Sets the knee point of the gamma curve. This setting can be adjusted from 50 to 109. (Default: 95)
[Saturation]: Adjusts color saturation in highlights. This setting can be adjusted from -10 to 10. (Default: ±0)
Input
Outp
ut
Point
Black Gamma
COP
Y