Canon EOS C500 PL - Manual (Page 141)

141
Video Output Configuration
Video Output Configuration for MXF Mode
Refer to the following table for the video output configuration from each terminal during recording and playback.
1 Depending on the signal, you can switch between the P and PsF setting (A 145) for output.
2
Set [¢ Video Setup] (in mode) or [ 4K/2K/MXF Setup] (in mode) > [HD/SD SDI] > [Output] to [HD], [SD]
or [Off].
3 You can display zebra patterns on an external monitor during HD output (A 83). Zebra patterns will not be output during SD
output.
4
When the camera is connected via HDMI OUT terminal to an external monitor, the video signal output from the HD/SD SDI
terminal will be the same as that from the HDMI OUT terminal.
5 Video output will automatically switch to HD or SD, depending on the capability of the external monitor.
6
Set [¢ Video Setup] (in mode) or [ 4K/2K/MXF Setup] (in mode) > [SYNC OUT] > [Output] to [HD-Y] (HD
component video, luminance signal) or [Composite] (SD analog composite signal).
Operating modes:
Video configuration
HD/SD SDI
terminal
2, 3, 4
HDMI OUT
terminal
3, 5
SYNC OUT
terminal
6
Resolution Frame rate
HD 1
( mode)
HD
( mode)
SD HD SD HD SD
1920Ч1080
1440Ч1080
59.94i 1080/59.94i
1080/59.94i 480/59.94i 1080/59.94i 480/59.94P 1080/59.94i 480/59.94i
29.97P
1080/29.97
(P/PsF)
23.98P
1080/23.98
(P/PsF)
50.00i 1080/50.00i
1080/50.00i 576/50.00i 1080/50.00i 576/50.00P 1080/50.00i 576/50.00i
25.00P
1080/25.00
(P/PsF)
24.00P
1080/24.00
(P/PsF)
1080/60.00i – 1080/60.00i – 1080/60.00i –
1280×720
59.94P 720/59.94P
720/59.94P 480/59.94i 720/59.94P 480/59.94P 720/59.94P 480/59.94i 29.97P 720/29.97P
23.98P 720/23.98P
50.00P 720/50.00P
720/50.00P 576/50.00i 720/50.00P 576/50.00P 720/50.00P 576/50.00i
25.00P 720/25.00P
24.00P 720/24.00P 720/60.00P – 720/60.00P – 720/60.00P –
COP
Y