Canon EOS C500 PL - Manual (Page 24)

Preparing the Power Supply
24
Attaching the Battery Pack
1 Set the Q switch to OFF.
2 Slide the BATT. OPEN switch in the direction of the arrow and open
the battery compartment cover.
3 Insert the battery pack all the way into the compartment as shown
in the illustration and press it gently toward the left until it clicks.
4 Close the battery compartment cover.
Removing the Battery Pack
1 Set the Q switch to OFF.
2 Slide the BATT. OPEN switch in the direction of the arrow and open
the battery compartment cover.
3 Holding down the RELEASE latch, slide the battery pack toward the
right and then pull it out.
4 Close the battery compartment cover.
Checking the Remaining Battery Charge
When the camera is turned on, you can check the remaining battery
charge by looking at any recording/playback screen or the [Battery/Hour Meter] status screen (A 185). When
the camera is turned off, use one of the following methods to check the approximate remaining battery charge.
For batteries compatible with Intelligent System, press the CHECK
button. An indicator will light for approximately 3 seconds and show the
approximate remaining battery charge.
0-25%
26-50%
51-75%
76-100%
CHECK button
Battery charge indicator
COP
Y