Avaya IP OFFICE EU24 - Manual (Page 47)

Function Key Programming Function Keys - Page 47
IP Office 2420 + EU24 User’s Guide Function Keys - Page 47
40DHB0002UKEG – Issue 4 (9th February 2004) Function Key Programming
RBak - Cancel Ringback When Free
Cancels any set ringback when free function.
This function does not require any data entered when programmed. This function
cannot be programmed through the phone by the user.
Pressing
RBak- switches off any set ring back when free. If the ringback was set
using a AutCB key, that key will still appear with a symbol that can be cancelled
by pressing the AutCB key again.
[User | Digital Telephony | Advanced | Miscellaneous | Cancel Ringback
When Free]
RBSeq - Set Ringback Sequence
Sets the ringing pattern (sequence) used for voicemail and ringback calls.
This function is currently not supported on the 2420 telephone.
Recor - Call Record
Records the current call at the specified target extension.
This function requires entry of a target extension number when programmed. This
function cannot be programmed through the phone by the user.
When
Recor is pressed, the target extensions current call is recorded into their
voicemail mailbox.
Note: This function requires Voicemail Pro to be installed. If advice of call recording
is enabled, the call parties will hear a warning before the recording takes
place. In some locations it may be a legal requirement to advise callers that a
call is being recorded.
[User | Digital Telephony | Advanced | Call | Call Record]
See also:
•
Listn - Call Listen on page 45.
• Steal - Call Steal on page 54.
Relay - Relay Pulse
Pulse the specified external output relay (1 or 2) on for 5 seconds.
This function requires the relay switch (1 or 2) on the telephone system to be entered
when programmed. This function cannot be programmed through the phone by the
user.
Pressing
Relay switches the specified relay on for 5 seconds and then off.
[User | Digital Telephony | Advanced | Relay | Relay Pulse]
Rely+ - Relay On
Switch the specified external output relay (1 or 2) on.
This function requires the relay switch (1 or 2) on the telephone system to be entered
when programmed. This function cannot be programmed through the phone by the
user.
Pressing
Relay switches the specified relay on.
[User | Digital Telephony | Advanced | Relay | Relay On]