Avaya IP OFFICE EU24 - Manual (Page 27)

Function Key Programming Function Keys - Page 27
IP Office 2420 + EU24 User’s Guide Function Keys - Page 27
40DHB0002UKEG – Issue 4 (9th February 2004) Function Key Programming
Longhand Programming
1. Press Admin or Admin 1. See Function Key Programming on page 25.
2. Pressing Expl? to switch to longhand programming mode.
3. Press Next until the required feature required is shown, then press Selct .
4. If the feature requires some data to be entered, [ is shown at the bottom of the
display. Enter the data using the normal telephone keypad.
5. The upper part of the display reverts to showing the features currently assigned to
each and key.
6. Use the or keys to move between the pages of display keys.
7. Select the display key against which to program the new feature by pressing that
or key
CAUTION: Do not select the slot used for the Admin function. Replacing this
function will lock the phone for further programming until reset through
the telephone system by your System Administrator.
8. If the display slot is not already used, the display shows BUTTON
PROGRAMMED!.
• Press
EXIT to end programming or
• Press Cont to continue programming other functions.
9. If the display slot already has a programmed function, the display shows
FEATURE ON BUTTON.
• Press Repla
to replace that existing function with the one just programmed.
The display then shows BUTTON PROGRAMMED! as above.
• Press Keep to keep the existing function and forget the function just
programmed.
• Press Delete to delete the existing function and forget the function just
programmed.