Canon imagePROGRAF iPF825 - Manual (Page 403)

Note
• The settings in the Paper Detailed Settings dialog box are temporary; after the print job finishes the settings
of the printer operation panel are restored.
Drying Time
Between Pages
This sets the wait time for the ink to dry between each completely printed sheet and the output of the sheet.
Setting Details
Printer Default The settings of the printer operating panel are applied.
None The paper is ejected immediately after printing.
30sec. / 1min. / 3min. / 5min. /
10min. / 30min. / 60min. The sheet is ejected when the specified time after printing has elapsed.
Between Scans
This sets the wait time between line scans during printing.
Setting Details
Printer Default The settings of the printer operating panel are applied.
None The printing continues to the next line immediately after the last line.
1sec. / 3sec. / 5sec. / 7sec. / 9sec. The printing continues to the next line after the set time.
*For the media type that has problems, such as ink smears on the page or colors
that seem uneven during borderless printing etc., increase the value for this setting.
Roll Paper Margin for Safety
Near End Margin
This sets the length of the near end margin of the roll paper.
Setting Details
Printer Default The settings of the printer operating panel are applied.
3mm Print at a standard size.
*Select for Media Type that has no problem when printing with a standard size
margin.
20mm This setting sets the margin about 17 mm (in the feed direction) longer than the
standard margin for the media size.
*This is for Media Type that has a strong tendency to curl, causing the printhead to
scratch the surface.
Important
• If you make the margin (white space) too small, this could disturb the print image or cause the printhead to
scour the surface of some types of media. If the printhead scours the surface of the media, adjust the height of
the printhead.
Cut Speed
This selects the auto cut speed.
Windows Software > HDI Driver >
iPF825 Paper Detailed Settings
4
387