Canon VIXIA HF R52 - Manual (Page 168)

168 Š
Additional Information
Check the memory card
- Cannot access the memory card. Check the memory card and make sure it is inserted cor-
rectly.
- A memory card error occurred. The camcorder cannot record or display the image. Try remov-
ing and reinserting the memory card, or use a different memory card.
- You inserted a MultiMedia Card (MMC) into the camcorder. Use a recommended memory card
( A 23).
- If after the message disappears, 9 appears in red, perform the following: Turn off the cam-
corder and remove and reinsert the memory card. If 8 turns back to green you can resume
recording/playback. If the problem persists, save your recordings ( A 105) and initialize the
memory card ( A 29).
Check whether the lens cover is open
- Slide the lens cover switch down.
Do not disconnect the power source. Cannot write data with this connection. To write data to
the camcorder, connect the compact power adapter then reconnect the camcorder and
computer. Do not disconnect the USB cable unless you first use the computer to safely end
the connection.
- The camcorder cannot be operated while it is not being powered by the compact power
adapter and is connected to a computer with the supplied USB cable. In addition, scenes can-
not be written back and music files cannot be transferred to the camcorder. To avoid corrupt-
ing the data in the camcorder’s memory, use the computer’s Safely Remove Hardware
function to end the connection and disconnect the USB cable before using the camcorder.
- To transfer files to the camcorder, use the computer’s Safely Remove Hardware function to
end the connection, disconnect the USB cable, power the camcorder using the compact
power adapter and only then connect it to the computer again.
Do not disconnect the power source. Do not disconnect the USB cable unless you first use
the computer to safely end the connection.
- When the camcorder is in mode and is connected to the computer with the supplied
USB cable, the camcorder cannot be operated. Disconnecting the USB cable or power source
while this message appears may result in permanent loss of the recordings in the camcorder.
Use the computer’s Safely Remove Hardware function to end the connection and disconnect
the USB cable before using the camcorder.
File name error
- The file or folder number has reached its maximum value. Save your recordings ( A 105), set
1 > q > [File Numbering] to [Reset] and initialize the memory ( A 29).
Initialize only using the camcorder
- There is a problem with the file system that prevents accessing the selected memory. Initialize
the memory with this camcorder ( A 29).
LCD Screen has been dimmed Use the [LCD Backlight] setting to change the brightness
- Change the 1 > t > [LCD Backlight] setting to [Normal] or [Bright].
COP
Y