ATEN ACS-1208AL User Manual
Page 15
Note: 1. Since the ACS-1208AL only has eight ports, only the
top row of LEDs (corresponding to Ports 1 - 8) are
active on that unit. On the ACS-1216AL, both rows
are active.
2. When the ACS-1208AL / ACS-1216AL is first
powered on, the On Line and Selected LEDs blink
one after the other as the Switch performs a self-test.
4. Keyboard
5. Power LED
Lights BLUE to indicate that the unit is receiving power.
6. Slide Release
For convenience and to prevent inadvertent damage to the
console, the ACS-1208AL / ACS-1216AL has a mechanism that
locks it in the “In” position to prevent it from accidentally sliding
out. In order to slide the the console out, you must first release it
by moving this tab sideways.
7. Rack Mounting Brackets
There are rack mounting brackets attached to each corner of the
unit. They are used to secure the chassis to a system rack. Refer to
Appendix C for rack mounting details.
8. Touchpad
9. LCD Display Controls
The LCD On/Off Switch is located here, as well as buttons to control
the position and picture settings of the LCD display. See the LCD
OSD Configuration section p. 1-10, for details.
10. Reset Switch
Pressing this switch in performs a system reset. This switch is
recessed and must be pushed with a thin object - such as the end
of a paper clip, or a ballpoint pen.
2003-01-28
Introduction
1-7