ATEN ACS-1208AL - Manual (Page 32)

Hotkey
Beeper
Control
The Beeper can be Hotkey toggled On and Off (see Activate Beeper, p.
4-9). To toggle the Beeper, key in the following Hotkey combination:
1. Invoke Hotkey Mode (see p. 3-1).
2. Press [B]
After you press B, the Beeper toggles On or Off. The Command Line
displays Beeper On or Beeper Off for one second; then the message
disappears and you automatically exit Hotkey Mode.
Hotkey
Summary
Table
[Num Lock] + [-] [Port ID] [Enter] Switches access to the computer that
corresponds to that Port ID.
[T] [n] [Enter] Sets the Auto Scan interval to n
seconds - where n is a number from 1
- 255.
[A] Invokes Auto Scan Mode.
When Auto Scan Mode is in effect, [P]
or Left Click pauses Auto Scanning.
When Auto Scanning is paused,
pressing Any Key or another Left Click
resumes Auto Scanning.
[ ← ] Invokes Skip Mode and Skips from
the current port to the first accessible
port previous to it.
[ → ] Invokes Skip Mode and Skips from
the current port to the next accessible
port.
[ ↑ ] Invokes Skip Mode and Skips from
the current port to the last accessible
port of the previous Station.
[ ↓ ] Invokes Skip Mode and Skips from
the current port to the first accessible
port of the next Station.
[B] Toggles the Beeper On or Off.
2003-01-27
ACS-1208AL / ACS-1216AL User Manual
3-6