ArtDio IPF-2000 - Manual (Page 11)

IPF-2000 User Manual
11
5. Configure IPF-2000 Using Keypad
IPF-2000 can be configured with its keypad or on a web page. The following table below
illustrates the configuration function keys when using the keypad:
Keys Function
SPD / HOLD To change settings when using the keypad configuration.
REDIAL / MUTE To main menu options when using the keypad configuration.
VOL - To the next page when using the keypad configuration.
VOL + To the previous page when using the keypad configuration.
Enter To confirm the setting when using the keypad configuration.
5.1 Network Settings
The default network setting for IPF-2000 is DHCP. Therefore, if you connect your IPF-2000 to
a DHCP network, it will direct connect to the Internet without any network setting.
If the network environment is PPPoE or Static IP, please change the network setting on your
phone to PPPoE or Static IP. You can use the keypad to change your phone network setting.
If you don’t know what kind of network environment you are at, please contact your Internet
Service Provider.
Use the keypad configuration and choose the 【network settings】. Please configure your
phone to DHCP, Static, or PPPoE according to your network environment.
5.1.1 PPPoE Setting
1. Connect the PPPoE network to the LAN port of the IPF-2000, and then plug in the power.
2. Press # (Hold the “#” key) and then reboot IPF-2000
Æ LCD shows【password】 Æ Press
1234 and then press ENTER Æ LCD shows 【network settings】.
3. Press ENTER
Æ LCD shows【iptype】Æ press SPD/HOLD Æ Blinking cursor Æ Press 2
and then press ENTER. (2 sets your networking settings the PPPoE mode)
4. Press ENTER Æ LCD shows 【pppid】Æ Press SPD/HOLD Æ Enter PPPoE account
number and then press ENTER.
5. Press ENTER Æ LCD shows【pppin】Æ Press SPD/HOLD Æ Enter PPPoE password and
then press ENTER Æ Press ENTER again to complete the configuration.
™ If you want to enter symbols or characters such as @, A, a, B, b, C, c, please refer to the
IPF-2000 Keypad and Symbols Mapping Table in Appendix 11.1.