ArtDio IPF-2000 - Manual (Page 19)

IPF-2000 User Manual
19
• When select “Prefix” from Use Dialplan drop down list, please enter the
number provided by ISR, card number and “#”. For example
14589653185#
• With MGCP protocol used, please enter the Local name of the
EndpointID in this field.
• With SIP protocol used, enter the SIP Proxy account.
PIN
• When H.323 protocol is used to logon a Gatekeeper, enter the
password or H.235 authentication password.
• When SIP protocol is used to logon a SIP Proxy Server, please enter
the password in this field.
• When select “Prefix” from Use Dialplan drop down list, please enter the
password provided by ISR, card number, and “#”. For example 3185#.
• With MGCP protocol used, enter the domain name of the EndpointID in
this field.
※ With MGCP protocol is used, as requested by some system, please
add the bracket with the domain name. For example, [voiptest.com].
Register Port
According to used protocol, set as follows:
• With H.323 protocol used,
ƒ If the gatekeeper is used, the register port works as the
gatekeeper’s monitor port. The default value is 1719.
ƒ If the gatekeeper is not used, the register port works as the end
point device or the gatekeeper’s monitor port. The default value is
1720.
• With MGCP protocol used, this port is the Call Agent’s receive port. The
default value is 2727.
• With SIP protocol used, the default setting is 5060.
Signal Port
With H.323 protocol used, this port is mapped to the Q.931 port. For
H.323, the Q.931 call usually uses TCP protocol. The value can be set
between 1024 and 65535.
Control Port
• With H.323 protocol used, this port is the H.245 port using TCP
protocol. H.245 protocol defines call control signal, and uses TCP
protocol. The value can be set between 1024 and 65535.
• With MGCP or SIP protocol used, there is no specific request for this
port. You can enter any number.
※ If there are many IPF-2000 traversing the NAT at the same time, each
IPF-2000 should be assigned with different port number.
Register TTL
This defines how many seconds a register message will be sent to the
server. The default setting is 60 seconds.
RTP TOS
Fill TOS segment of IP header in RTP digital follow here. Detailed
information please refers to IP protocol information.
RTP Port
RTP port is the port transferring and receiving voice flow using UDP
protocol. Please enter an even number between 1024 and 65535 in this
field.
Local Type
This parameter refers to how IPF-2000 login a Gatekeeper or SIP Proxy
server. The meaning of each item is as follow: