2 static ip setting, 3 dhcp setting, 2 protocol settings – ArtDio IPF-2000 User Manual
Page 12: Protocol settings
IPF-2000 User Manual
12
5.1.2 Static
IP
Setting
Please enter the Static IP comes from your ISP, or the Private IP address, Subnet Mask, and
Default Gateway IP address in your company.
1. Connect the RJ-45 Ethernet Cable to the LAN port on the IPF-2000, and then plug in the
power.
2. Press
# (Hold the “#” key) and then reboot IPF-2000
Æ LCD shows【password】Æ Press
1234 and then press ENTER
Æ LCD shows【network settings】.
3. Press
ENTER
Æ LCD shows【iptype】Æ press SPD/HOLD Æ Blinking cursorÆ Press 0
and then press ENTER. (0 sets your networking settings to the Static IP mode)
4. Press
ENTER
Æ LCD shows【ip】Æ Press SPD/HOLD Æ Blinking cursor Æ Input IP
address (XXX*XXX*XXX*XXX) and then press ENTER.
5. Press
ENTER
Æ LCD shows 【subnet mask】Æ Press SPD/HOLD Æ Blinking cursor Æ
Input Subnet Mask information (XXX*XXX*XXX*XXX) and then press ENTER.
6. Press
ENTER
Æ LCD shows【router】Æ Press SPD/HOLD Æ Blinking cursor Æ Input
default gateway information (XXX*XXX*XXX*XXX, where X is any number or character)
and then press ENTER.
5.1.3 DHCP
Setting
1. Connect the RJ-45 cable to the LAN port on the IPF-2000, and then plug in the power.
2. Press
# (Hold the # key) and then reboot IPF-2000
Æ LCD shows【password】Æ Press
1234 and then press ENTER
Æ LCD shows【network settings】.
3. Press
ENTER
Æ LCD shows【iptype】Æ Press SPD/HOLD Æ Blinking cursor Æ Press 1
and then press ENTER (1 sets your networking settings to the DHCP mode).
5.2 Protocol
Settings
1. Press
# (Hold the “#” key) and then reboot IPF-2000
Æ LCD shows【password】Æ Press
1234 and then press ENTER
Æ LCD shows【network settings】 Æ Press VOL - Æ LCD
shows【protocol settings】.
2. Configure if IPF-2000 needs to login to the server.
【protocol settings】
Æ Press ENTER several times Æ LCD shows【service】.
• If the IPF-2000 is not going to register on the server, press SPD/HOLD Æ Press 0 (Not
register to the server) and then press ENTER.
• If the IPF-2000 is going to register on the server, press SPD/HOLD Æ Press 1 (Register
to the server) and then press ENTER.