Getting started, When you first plug in your phone, Updating your phone – Aastra Telecom 9112i IP PHONE User Manual

Page 9: Start up screens, Incomplete config, No service, When you first plug in your, Phone

Advertising
background image

9112i IP Phone User Guide

3

Getting Started

Getting Started

The 9112i must be set up and
configured prior to its first use.
This section describes phone
behaviour and start up screens you
may see when the phone is first
plugged in,
or when it is restarted.

When You First Plug in Your
Phone

The 9112i automatically begins the
start up sequence as soon as it is
connected. The phone goes
through this process the first time
you plug in your phone and every
time you restart your phone. The
first screen the phone displays is
the Aastra splash screen.

Updating Your Phone

After displaying the Aastra splash

screen, the 9112i checks settings

and looks for new configuration

and firmware updates for the

phone from the server. If a new

update is found, the phone

displays the message “Updating
Config

” or “New Firmware”. This

may take a few moments while the

phone downloads the latest

updates.

Note: New updates to your phone can

be automatically scheduled from
the server. This is set up on the
phone system by your system
administrator and should be
scheduled during non-business
hours or slow call periods.

Important! Do not unplug or remove
power to the phone while it is checking
or installing firmware.

Start up Screens

After the phone displays the
Aastra splash screen or after
downloading an update (if an
update was available), the phone
displays the Idle State screen:

The basic Idle State screen lists
your name, extension, and today's
date and time. This screen is
shown whenever your phone is not
in use.

Incomplete Config.

If your phone displays a
“No Service” message without any
extension or user name at the end
of the start up sequence instead of
the Idle State screen, this means
your system administrator has not
set up your extension correctly.
Contact your system administrator
for assistance.

No Service

The “No Service” or “Network
disconnected

” prompt appears on

the display and the telephone
status light turns on when the
phone is not properly connected to
the network, or the account has not
been configured by the
administrator. The phone also
displays the default time and date
of 12:00am Jan. 1st, 2000. Check
that the cables are tightly
connected to the phone and to the
wall jack.

)=IJH= ' E

Checking for new

firmware...

John Burns

9054550055

Jun 8 2:55pm

Advertising