Amana RS2320006 - Manual (Page 13)

Disassembly Procedures
13 RS2320006 Rev. 0
To avoid risk of electrical shock, personal injury or death;
disconnect power supply source before servicing, unless
testing requires it.
WARNING !
Maintop
NOTE: Requires range to be moved out away from the
wall.
1. Turn power off to unit.
2. Slide range forward on slide guards.
NOTE: Usage of slide guards, prevents the unit from
damaging the floor.
3. Unplug the power cord.
4. Remove screws securing maintop to oven frame,
located in front, above the oven door.
5. Raise and support the maintop to gain access to wire
terminals.
6. Label and disconnect wire terminals from elements.
7. Remove screws securing elements support brackets
to the maintop. Type of brackets may vary.
NOTE: When removing elements from maintop mark or
label elements for reassembling.
Typical maintop assembly
8. Remove screws securing hinge to the maintop.
9. Remove maintop.
10.Reverse procedure to reinstall.
Door Latch Motor, Plunger Light Switch,
and Latch Switch
1. Disconnect electrical supply to range.
2. Remove maintop, see “Maintop” procedure.
3. Remove screws in front and on right side securing
latch mechanism to range front frame and galvanized
insulation retainer.
4. Carefully maneuver assembly to the rear to clear door
catch and light switch plunger.
5. Move assembly to the left side then lift up on the right
side. After clearing the insulation retainer turn
assembly upside down to access screws securing
components to mounting plate.
6. Reverse procedures to reassemble.
NOTE: Latch motor, rod, and catch are not sold
separately.
Bake Element
1. Turn off power to unit.
2. Remove all utensils and racks from oven cavity.
3. Remove oven door, see "Oven Door" procedure.
4. Remove screws securing oven bottom to the bottom of
the oven cavity.
5. Remove bake element cover.
• Push downward on the front portion of the bake
element cover. This will raise the rear of the cover.
• Grasp the back portion of the cover and slide
cover towards the rear of the oven cavity,
releasing the front portion of the cover from the
oven cavity.
• Remove the cover from the oven cavity.
6. Remove screws securing bake element to the oven
cavity.
7. Pull element and wires into oven cavity.
NOTE: Pull bake element forward enough to disconnect
terminals on each element leg.
8. Disconnect terminals from each element leg.
9. Reverse procedure to reinstall bake element.