Amana RS2320006 - Manual (Page 39)

Sigma Control Programming Instructions
RS2320006 Rev. 0 D 5
Delayed Baking
Set oven to begin and end baking at a later time. Oven
control automatically calculates starting time.
1. Place food in oven.
2. Press STOP TIME button.
•
Default time displayed is current time of day.
3. Use the digit pads (1 through 0) to enter the desired
stop time.
•
Stop time can be set up to 11 hours and
59 minutes ahead of current time of day.
4. Press COOK TIME pad.
•
Cook time can be set up to 11 hours and
59 minutes.
•
1 minute minimum cooking time.
•
Electronic control automatically calculates start
time.
5. Press BAKE pad.
•
Bake temperature can be set from 170
G
F to 550
G
F.
•
Use the digit pads to enter desired bake
temperature.
6. Press START pad.
•
Oven will automatically begin to heat at calculated
start time.
•
ON displays when oven begins to heat.
•
To adjust cook time, press COOK TIME pad while
the remaining cook time is displayed. Cook time
can then be adjusted.
•
When cooking time has elapsed an end of cycle
signal sounds. Oven signal sounds 3 times, then
once every 30 seconds until OVEN CANCEL pad
is pressed. END also displays.
7. Press OVEN CANCEL to cancel baking.
Self-cleaning
Self-clean feature uses high oven temperature to clean
oven interior. For the oven to operate through a
complete self-clean cycle, the self-clean must be set
when the oven is cool.
1. Prepare oven for self-cleaning.
2. Close
door.
3. Press CLEAN pad.
•
SET CLEAN TIME flashes in display.
•
The default self-clean cycle length of 3 hours
displays.
•
Adjust clean cycle length by using digit pads
(1 through 0).
•
Clean cycle can be set from two to four hours in
one minute increments.
4. Press START pad.
•
CLEAN, TIME, LOCK, ON and both bake and
broil element graphics display.
•
Surface burners should not be used until
completion of self-clean cycle.
•
At the end of self-clean cycle, END displays. No
signal tone will sound.
•
ON no longer displays. Oven will shut off.
•
LOCK will remain on until oven reaches a cooler
temperature.
•
LOCK will shut off when door has unlocked. Oven
cavity will be hot to the touch.
•
DO NOT attempt to open door prior to LOCK
shutting off.
Interrupting the self-clean cycle
To stop a self-clean cycle that has already started follow
these steps. If an interruption occurs mid cycle, the oven
will remain locked, even though the cycle has stopped,
until the oven cavity has cooled to a lower temperature.
1. Press OVEN CANCEL pad.
2. When oven has cooled to a lower temperature,
LOCK light turns off. Door can be opened. DO NOT
force door. This can cause damage to the latch.