Amana RS2320006 - Manual (Page 7)

7 RS2320006 Rev. 0
General Information
Follow these recommendations only as a guide for times
and temperature. Times, rack position, and temperatures
may vary depending on conditions and food type. For
best results, always check food at minimum time. When
roasting, choose rack position based on size of food
item.
Oven Rack Placement
Position oven rack before turning on oven.
1. Pull rack forward to stop position.
2. Raise front edge of rack and pull until rack is out of
oven.
3. Place rack in new rack position.
• Curved edge of rack must be toward rear of oven.
Pan Placement
• Keep pans and baking sheets 2 inches from oven
walls.
• Stagger pans placed on different racks so one is not
directly over the other.
Removing Oven Door
CAUTION !
To avoid personal injury or property damage, handle
oven door with care.
• Door is heavy and can be damaged if dropped.
• Avoid placing hands in hinge area when door is
removed. Hinge can snap closed and pinch hands.
• Do not scratch or chip glass, or twist door. Glass
may break suddenly.
• Replace door glass if damaged.
1. Pull out or remove storage drawer to avoid damaging
finish.
2. Fully open oven door.
3. Push hinge locks down toward door frame, to the
unlocked position.
• This may require a flatblade screwdriver.
4. Firmly grasp both sides of top of oven door.
5. Close door to first stop position.
6. Lift door up until hinge arm is clear of the slot.
Hinge Lock
Oven
Door
Oven Frame
Replacing Oven Door
1. Grasping door top firmly, seat indentation of hinge
arm into bottom edge of the hinge slot.
• Door should be at the first stop position angle.
2. Fully open oven door.
3. Push hinge locks up against the front frame of the
oven cavity to locked position.
4. Close oven door.